1, USES:

glass washing machine CP-2500A used for cleaning and drying the upper and lower surfaces of ordinary plate glass and high quality low-e glass,it is composed of incoming segment, cleaning air-drying segment and outgoing segment.

2, Structural characteristics:

1. Aluminum alloy assembly structure, no scrap concept, permanent use,
High efficiency, energy saving of 70% efficiency.

2. All remaining sheet metal parts are made with advanced mechanical spray

Paint or powder;

3. The rubber roller uses vulcanized rubber and stainless steel shaft.

4. The cleaning part that comes in contact with water is made of stainless steel.

5. In the cleaning department, the wind staff lifts up and down as a whole. The maximum lift is 350 mm, which is convenient for cleaning and maintenance.

6. Three pairs of brushes (Ø150mm) stainless steel shaft construction (Low-E glass, regular coated glass, daylight coated glass can be cleaned without damaging the coated surface).

7. Two sets of special stainless steel aluminum alloy air knife configuration, strong wind, good drying effect, with heating system (with temperature control, opening and closing is optional).

8. The fan is equipped with an air filter in the air inlet chamber, which has a large amount of air and has a good air drying effect. The entire windbox is located at the top of the workshop and has air filters on the sides for easy inspection and cleaning.

9. The main drive gear is driven by frequency conversion and digital display. The rotation of the brush roller in the cleaning section is driven by the independent belts of the upper and lower motors. With stable frequency conversion speed adjustment and long service life, it is possible to clean special glass that is in high demand.

10. Mechanical button control, washing machine digital display, easy operation, easy operation, and convenient maintenance.

11. The washing machine's aquarium is installed outdoors, which is convenient for cleaning, replacing and inspecting the aquarium, and the washing effect of the washing machine will be cleaner.

12. PLC control and touch screen display are optional, convenient for operator operation and maintenance, and can be tightly connected to edge grinders from various manufacturers. (Must be purchased separately)

3, Technical parameters:

1. Maximum glass width: 2500mm (effective maximum: 2650mm)

2. Minimum glass specifications: 400 mm x 400 mm (limited to left and right single rows)

3. Glass thickness: 3mm-25mm (digital display)

4. Speed range: Glass thickness is 3-25mm Vmax = 1-12m / min

5. Main drive and electric brush speed adjustment mode: Frequency conversion speed adjustment

6. Workbench height: 900 ± 25mm

7. Total power: 42KW (Flood control air heat: 15KW)

8. Water sources: self-circulating, tap water (according to private water standards), and deionized water supplements (deionized water equipment must be provided by the purchaser)

9. Power supply: 380V 50Hz

10. Dimensions (length x width x height): Approximately 6260 x 4800 x 3100

11. Weight: Approximately 3940kg